I have an Aeon Motion sensor DSB05-ZWUS/ZW07 that no longer senses motion nor responds.
With this unit plugged into USB power I wanted to remove/exclude and add/include. the Red light is on with USB power however I can't remove nor re-add this unit. I have tried a factory reset.
the question. How do you manually remove or exclude node or Z-Wave unit from the interface controller that is dead?
Devoir
With this unit plugged into USB power I wanted to remove/exclude and add/include. the Red light is on with USB power however I can't remove nor re-add this unit. I have tried a factory reset.
the question. How do you manually remove or exclude node or Z-Wave unit from the interface controller that is dead?
Devoir
Comment