Just bought some ZLink WD 100 wall dimmers.... using HS3 and Ztroller.
Installed and added them and figured all was ok. Then went to add to my events and there is only an OFF button, no on, and clearly cannot control.
Getting this message about no node information...
When loading the Ztroller into homeseer I get:
Z-Wave manufactuter information for node 102, ID: 789-315H (Stelpro), Type: 17479=4447H, ID: 12340=3034H
Error: Cannot get additional details about node 102 as there is no node information available.
So, it does not get an on off button, etc.
Tried all re-scans, remove and re-add, tried different Z-Troller (I have 2), etc.
Everything else works, just this products. Guess they are crap?
Greg
Installed and added them and figured all was ok. Then went to add to my events and there is only an OFF button, no on, and clearly cannot control.
Getting this message about no node information...
When loading the Ztroller into homeseer I get:
Z-Wave manufactuter information for node 102, ID: 789-315H (Stelpro), Type: 17479=4447H, ID: 12340=3034H
Error: Cannot get additional details about node 102 as there is no node information available.
So, it does not get an on off button, etc.
Tried all re-scans, remove and re-add, tried different Z-Troller (I have 2), etc.
Everything else works, just this products. Guess they are crap?
Greg
Comment