I have a Fibaro double switch 2 with a mains-powered PIR sending switched live to S1, but it randomly triggers. I can't be sure it isn't the PIR 100%, but I'm getting it often when I load a page in HS4. Just randomly decides the device is on. I've tried removing and re-adding, even resetting the device in between (which improved the connection). I have 2 other devices (one other double switch and one fibaro dimmer) in the same location, all by the secondary znet and they work absolutely fine. Any suggestions to debug?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.