Perhaps I just do now know how to set up an IR control page to record programs but I have not been successful in getting anything recorded. My control item setup follows:
Control Item IR Setup
Record Command Minutes To Pad : 0
String to Pause IR output: ,,,
How many characters should channel numbers be? 2 0's will be appended.
Change Device - Select the Channel Change Device from the Infrared Devices or enter an IR Device in the textbox below.
Change Channel Prepend IR Command
Change Channel Device
Change Channel Device : Tolshiba_VCR
Change Channel Append IR Command
Record Device - Select the Record Device from the Infrared Devices or enter an IR Device in the textbox below.
Record Device : Toshiba_VCR
Record Device
Record Device Prepend IR Command
Record Device Record Command : Record
Record Device Append IR Command
Use An Event To Stop Recording : Yes
Record Device Prepend Stop Command
Record Device Stop Command : Stop
Record Device Append Stop Command
Enable IR Time (h:mm am/pm) : 1:00 AM
Disable IR Time (h:mm am/pm) : 1:00 AM
All of the required IR commands for, say, record on channel 24 work if sent with hs.sendir command in a script-shown below
Toshiba_VCR, 2,,,Toshiba_VCR, 4,,,Toshiba_VCR, Record,,,Toshiba_VCR,Stop
I do not know what I am doing wrong in setting up the control with HSTV. Perhaps someone can point me in the right direction.
Mark
Control Item IR Setup
Record Command Minutes To Pad : 0
String to Pause IR output: ,,,
How many characters should channel numbers be? 2 0's will be appended.
Change Device - Select the Channel Change Device from the Infrared Devices or enter an IR Device in the textbox below.
Change Channel Prepend IR Command
Change Channel Device
Change Channel Device : Tolshiba_VCR
Change Channel Append IR Command
Record Device - Select the Record Device from the Infrared Devices or enter an IR Device in the textbox below.
Record Device : Toshiba_VCR
Record Device
Record Device Prepend IR Command
Record Device Record Command : Record
Record Device Append IR Command
Use An Event To Stop Recording : Yes
Record Device Prepend Stop Command
Record Device Stop Command : Stop
Record Device Append Stop Command
Enable IR Time (h:mm am/pm) : 1:00 AM
Disable IR Time (h:mm am/pm) : 1:00 AM
All of the required IR commands for, say, record on channel 24 work if sent with hs.sendir command in a script-shown below
Toshiba_VCR, 2,,,Toshiba_VCR, 4,,,Toshiba_VCR, Record,,,Toshiba_VCR,Stop
I do not know what I am doing wrong in setting up the control with HSTV. Perhaps someone can point me in the right direction.
Mark
Comment