MeiKu (Roku Monitor and Control) version 3.2.0.9 (beta) is now available!

[sirmeili]

MeiKu v3.2.0.9 (Beta) is now available in the HomeSeer store and in the updater! (found in the beta section)
The following are included:

• Added new device type for tracking the media play state (stopped, playing, paused).

Please see the full descriptions here:
https://forums.homeseer.com/showthread.php?t=188175

Release notes Here:
https://forums.homeseer.com/showthread.php?t=188176

And request new features here:
https://forums.homeseer.com/showthread.php?t=188177

[Ltek]

sirmeili I made events using the Play, Pause & Stop. They are what I needed but they take too long to detect. Does it only work on the polling interval? Is Roku just too basic that they don't offer any API that uses notifications/sockets/etc?

[Guest]

This is polling .

[Ltek]

Thx Matt ... I'm done with Roku in my Home Theater, going back to a HTPC box. Roku is so behind: No TrueHD passthrough, no automation capabilities, etc. Its great when built-into TVs but for Hometheater it sux

[sirmeili]

I have my polling set to 10 s for all my rokus and have never had an issue. You could probably set it to less, but I would be careful with that. I can make it an "action" to decrease polling time via an event. I.E. once roku starts playing, you have an event to decrease polling to 1 or 2 seconds and when it's stopped it goes back up.

Lets brainstorm it up

[Ltek]

I have my polling set to 10 s for all my rokus and have never had an issue. You could probably set it to less, but I would be careful with that. I can make it an "action" to decrease polling time via an event. I.E. once roku starts playing, you have an event to decrease polling to 1 or 2 seconds and when it's stopped it goes back up.

Lets brainstorm it up

Event Action would be great!

BTW -- I set Logging to Info, and now no matter what I set it to it never stays, always reverts to Info. Tried reboot, etc. I think there is a bug? Running .0.9 beta

[sirmeili]

Event Action would be great!

BTW -- I set Logging to Info, and now no matter what I set it to it never stays, always reverts to Info. Tried reboot, etc. I think there is a bug? Running .0.9 beta

I will check into it. I did some major changes at one point and maybe it's not saving that setting.

[Ltek]

I will check into it. I did some major changes at one point and maybe it's not saving that setting.

Any update for this issue... its fills up my log...

[sirmeili]

I have a deployment tomorrow night so at the very latest I will fix it then (if not tonight).

[Ltek]

I have a deployment tomorrow night so at the very latest I will fix it then (if not tonight).

posted bug here... https://forums.homeseer.com/forum/me...ng-always-info