Announcement

Collapse
No announcement yet.

Plug-in not working as expected

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Plug-in not working as expected

    Hi,

    I've tried to follow all the instruction mentioned on this section of the forum but I still don't manage to get this plug in work correctly.

    I've created two events, one to "enable" the simulation, one to "disable" it.

    When i run the "enable" event the plugin turns on the test light, however it never goes into random mode, the light always stays on.

    When I run the "disable" event the light correctly turns off.

    My Option page looks like this:



    Any idea what I'm doing wrong, as I have no clue now.

    Thanks

    P.S. I'm running HS3 Pro Edition 3.0.0.297

    #2
    I too ran into this issue trying out the plugin tonight.

    It would seem you require at least two devices, and you must set the max devices to less than your total devices.

    So in my case, I had two test devices and set the max to 1.

    Then the random aspect of these two devices worked (with only one on at a time for a random period within the range set, then random delay after off, before the other device turned on ... loop).

    Perhaps this will solve your experience.

    Comment

    Working...
    X