Announcement

Collapse
No announcement yet.

Using an event trigger to arm/disarm

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Using an event trigger to arm/disarm

    Trial started today - HS3 version.

    I'm trying to use an event trigger to arm and disarm. I can only see device values in the condition pulldown. Pressing Arm or Disarm on the Security Keypad shows the Device Status changing to the different string values, but the actual Value in the Advanced tab on the device doesn't change and there's no device status change condition that I can see.

    How do you trigger an event to arm/disarm BLSecurity using a SH624 X10 Remote?

    Regards
    Michael
    Regards,
    Michael

    HS3, W10 Home, HSTouch, W800, Z-Stick+

    #2
    Log a ticket and provide a debug log of the issue. Attach it zipped to the ticket
    Cheers,
    Bob
    Web site | Help Desk | Feature Requests | Message Board

    Comment


      #3
      You're too fast! Or I'm too slow. The conditions showed up now. Don't know why they were'nt there before.

      Ah, it's because I was using Device Value... instead of BLRf: Security Remote Control Trigger.

      Regards
      Micahel
      Regards,
      Michael

      HS3, W10 Home, HSTouch, W800, Z-Stick+

      Comment

      Working...
      X