No announcement yet.

Plugin and AM non-connectivity

  • Filter
  • Time
  • Show
Clear All
new posts

    Plugin and AM non-connectivity

    I have purchased a HS hometroller S3 and downloaded the plugin, have 2 keypads, a cellular communicator, and the AM for the concord 4. I tried a serial cable initially and only got it to connect once to the AM. I then bought a serial to usb adapter. This is what I have now:

    Disconnect Concord Panel
    Comm Port Initialized. NOT Connected to Concord Panel

    I don't know what else to do. My panel is not complaining about the AM so it has some communication with the plugin and the AM to the panel, but it has yet to poll all my zones and user info.

    One of the main reasons for getting this setup was to change my provider and do my automation myself. If I don't get this running soon, I am going to give up and return the lot.
    Last edited by richdukester; September 12, 2015, 03:11 PM. Reason: somebody to look at it

    figured it out

    I had accidentally deleted the AM when I was troubleshooting other bus devices. If you do this, you can go to an empty slot on the bus devices under system programming while in installer mode.

    There a serial number with each device that which is printed on a small sticker. I re-keyed the serial number and voila, the AM came back to life and started talking with the plugin