2 smoke detectors

[gsegovia15]

Is there a way to add 2 wire smoke so homeseer can see it. I have 2 smokes in the house and they are connected. But since they are not wire to a zone homeseer don't show them. Is there away for the aux program 2 wire smoke to be added to homeseer. Thank you

I did notice that I can create a event with smoke detector aux program.

"EnvisaLink Receives Message: 2-Wire Smoke/Aux Alarm"

[waynehead99]

I just did the same thing over the weekend and couldn't find a way to associate it with a device. I even tried tricking the alarm panel by doing a zone follower which failed miserably.

I am still looking on how to do this, but think I will probably switch mine out for a 4 wire.

[gsegovia15]

I just did the same thing over the weekend and couldn't find a way to associate it with a device. I even tried tricking the alarm panel by doing a zone follower which failed miserably.

I am still looking on how to do this, but think I will probably switch mine out for a 4 wire.

I was thinking about creating a virtual Device and running the event to trigger it. I thought about switching for 4 wires too. But I'm a out of zones.