Announcement

Collapse
No announcement yet.

Bypass causes error in log (but works!)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Bypass causes error in log (but works!)

    Whenever I bypass a zone I get the error shown below in the log. However, it does bypass the zone as requested (and can be seen by accessing zones on DSC keypad).

    Any idea what's up?


    Feb-19 2:52:09 PM EnvisaLink WARNING Unknown command value = 616
    Feb-19 2:52:09 PM EnvisaLink INFO Partition 1 status change: Ready

    Feb-19 2:52:07 PM Device Control Device: EnvisaLink Alarm 12 - Garage South Motion Sensor to Bypass (-1000) by/from: CAPI Control

  • #2
    the 616 command is a new message that reports the bypass state of zones, it is not implemented yet in the plugin that's why you see a warning. I'm going to implement it this week, meanwhile you can just ignore it.

    Comment


    • #3
      That sounds like good news...we will be able to confirm bypass' now.

      Comment

      Working...
      X