Hi everyone,
Newby here, I just installed my DSC 1864, I used Zone one for a motion sensor and have 15 wireless window/door contacts. I have the alarm up and working and can communicate with my EVL 4. I can see it on my local IP. I have went through the installation steps for the plug-in and have a problem. Nothing is updating in HS3. I have the correct IP Address entered and entered the password and the Master Code still nothing. I have not named my zones yet but didn't think that mattered yet. I did read this here.... "in the User Settings section, assign one or several DSC User Ids to HS users".... in the installation steps in the user guide. Not sure what to enter here, Where do I get my DSC User ID? I have added some pictures to help.
Any assistance is appreciated
Thanks, Mike
Newby here, I just installed my DSC 1864, I used Zone one for a motion sensor and have 15 wireless window/door contacts. I have the alarm up and working and can communicate with my EVL 4. I can see it on my local IP. I have went through the installation steps for the plug-in and have a problem. Nothing is updating in HS3. I have the correct IP Address entered and entered the password and the Master Code still nothing. I have not named my zones yet but didn't think that mattered yet. I did read this here.... "in the User Settings section, assign one or several DSC User Ids to HS users".... in the installation steps in the user guide. Not sure what to enter here, Where do I get my DSC User ID? I have added some pictures to help.
Any assistance is appreciated
Thanks, Mike
Comment