Have set an event trigger
however its not triggering,
with debug mode on
im not seeing any such message in the log.
(note that same situation for Panel AC Restore)
i do see a bunch of other messages for trouble LED etc
If i use this trigger in the event
then it works as expected
notes
HS3 (latest)
envisalink plugin 3.0.0.42 (the latest in the updater)
envisalink 4 Firmware Version: 01.04.176
snapshot attached of log around the time i manually remove AC mains supply from DSC panel
This is with two events (one using verbose - which triggers as epxected, the other with the Panel AC trouble - which is not being triggered.
IF | EnvisaLink Receives Message: Panel AC Trouble |
however its not triggering,
with debug mode on
im not seeing any such message in the log.
(note that same situation for Panel AC Restore)
i do see a bunch of other messages for trouble LED etc
If i use this trigger in the event
IF | EnvisaLink Receives Message: Verbose Trouble Status Trouble = ACPowerLost |
notes
HS3 (latest)
envisalink plugin 3.0.0.42 (the latest in the updater)
envisalink 4 Firmware Version: 01.04.176
snapshot attached of log around the time i manually remove AC mains supply from DSC panel
This is with two events (one using verbose - which triggers as epxected, the other with the Panel AC trouble - which is not being triggered.
Comment