Hi Spud,
While experimenting with the plugin (3.0.0.17), I ran across a few puzzles. I have 'Logging off' set only for Motion detectors. Here's what I found:
1- Turning off logging for a Motion detector device works great, except that for every Motion detector activity the following log entries get trigged:
2- I (away) armed at the DSC keypad, then disarmed. On the HS Device management page, Envisalink device 'User access' reflects who armed/disarmed and at what time; the 'Partition' device reflects the status of the partition and at what time it last changed. But in the log, I only see entries for the door opened and closed during my arming test, no entry about arming/disarming (who, when).
So, before digging further into this, can you tell me what should normally be logged by the plugin?
While experimenting with the plugin (3.0.0.17), I ran across a few puzzles. I have 'Logging off' set only for Motion detectors. Here's what I found:
1- Turning off logging for a Motion detector device works great, except that for every Motion detector activity the following log entries get trigged:
EnvisaLink INFO Partition 1 status change: Ready - Force Arming Enabled
EnvisaLink INFO Partition 1 status change: Ready
So I thought of disabling the 'Partition' device logging, but I was worried I would lose arming and disarming events; so I did a test and found the followingEnvisaLink INFO Partition 1 status change: Ready
2- I (away) armed at the DSC keypad, then disarmed. On the HS Device management page, Envisalink device 'User access' reflects who armed/disarmed and at what time; the 'Partition' device reflects the status of the partition and at what time it last changed. But in the log, I only see entries for the door opened and closed during my arming test, no entry about arming/disarming (who, when).
So, before digging further into this, can you tell me what should normally be logged by the plugin?
Comment