Just installed my EnvisaLink 4 and the HS2 Envisalink plugin. Zone status shows up correctly under status. If I open a window, the zone status shows open. If I close it, the zone status shows closed.
However, if I create and event triggered on:
"Envisalink Trigger"
"Zone Open"
and then pick say "Hallway Motion" or any other zone, the event fails to run.
I'm trying to convert over from using my IT100 to using the EVL4.
However, if I create and event triggered on:
"Envisalink Trigger"
"Zone Open"
and then pick say "Hallway Motion" or any other zone, the event fails to run.
I'm trying to convert over from using my IT100 to using the EVL4.
Comment