I have noticed that when the plugin reads some zone names it is pulling in the default name of the zone - "Zone 16" for example. When I look in DL900 I see that the zone is named more descriptively - the way I originally named it - "living room motion" for example. When I perform a read section in DL900 it still shows. If I select read all in DL900 then it resets back to "Zone 16". So i correct it and perform a send Section. Repeat the process above and it resets back to "Zone 16". So clearly I am not storing this information correctly in the panel. At advice on how to get the name to stick in the panel? Thanks.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.