The advanced settings bring up an OpenWRT configuration with many features.
Unless using wireless I would shut off the interface for wifi in OpenWRT.
or you can log in at:
IPOFROUTER/cgi-bin/luci
The OpenWRT menus are a bit more flexible than the GL.Net menus.
and allows for adding some programs.
The main GL. net webpage does show updates and I use it to update the device.
I haven't posted much on the GLxx forum lately (pete over there) and here settled on the Nexx micro router for use with the OmniPro 2 panel.
Disabled IP6 too. (note that the settings in OpenWRT menu superceed the ones on the GL.inet menu)
So here used GL.iNet menu to upgrade firmware
and used OpenWRT menu to:
1 - configure firewall rules (80, 22 and HAI port)
2 - shut off IP6
3 - disable wireless (power sucker)
Original set up used panel 12VDC to 5VDC converter going to a micro USB power connector on the microrouter.
Newer set up now uses POE from the Leviton 42" side panel POE switch. The 42" panel also has 120VDC to 12VDC and 120VDC to 5VDC power supplies. Single 120VAC out of the Leviton Panel goes to an APC UPS.
xxx
Unless using wireless I would shut off the interface for wifi in OpenWRT.
or you can log in at:
IPOFROUTER/cgi-bin/luci
The OpenWRT menus are a bit more flexible than the GL.Net menus.
and allows for adding some programs.
The main GL. net webpage does show updates and I use it to update the device.
I haven't posted much on the GLxx forum lately (pete over there) and here settled on the Nexx micro router for use with the OmniPro 2 panel.
Disabled IP6 too. (note that the settings in OpenWRT menu superceed the ones on the GL.inet menu)
So here used GL.iNet menu to upgrade firmware
and used OpenWRT menu to:
1 - configure firewall rules (80, 22 and HAI port)
2 - shut off IP6
3 - disable wireless (power sucker)
Original set up used panel 12VDC to 5VDC converter going to a micro USB power connector on the microrouter.
Newer set up now uses POE from the Leviton 42" side panel POE switch. The 42" panel also has 120VDC to 12VDC and 120VDC to 5VDC power supplies. Single 120VAC out of the Leviton Panel goes to an APC UPS.
xxx
Comment