Announcement

Collapse
No announcement yet.

New Install help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    Reading several comments from folks about ethernet issues and the 10Mbps / Half duplex nature of the OmniPro II panel... I have the same panel, but it is connected to a Cisco SG200-24 smart switch... It has very few if any errors or issues. The SG200 detects it is a 10Mb interface half dup. (And passes traffic accordingly. There are a few collisions and but not much.) I will try to figure out how I can filter out Multicast packets. But for now.. This switch and Omni seem fine together and very few, if any problems, without the custom router in-between.

    If ONLY HAI were still alive to produce a next-generation panel!...

    Comment

    Working...
    X