Announcement

Collapse
No announcement yet.

Problem with alarm trigger (gas, CO, etc.)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Problem with alarm trigger (gas, CO, etc.)

    I am having a problem with the "UltraM1G3: Elk M1 Alarm Trigger" for certain alarm conditions. I have events configured as followed:

    If "UltraM1G3: Elk M1 Alarm Trigger" "Area 01" changes to "Fire Alarm"
    If "UltraM1G3: Elk M1 Alarm Trigger" "Area 01" changes to "Gas Alarm"
    If "UltraM1G3: Elk M1 Alarm Trigger" "Area 01" changes to "Carbon Monoxide Alarm"

    But the events do not fire when the Elk M1 goes into "gas" or "carbon monoxide" alarm. However the same event does work for "fire". I have not tested any other alarm condition.

    Here are the relevant log entries from the Elk M1:

    Code:
    01/08/2017 15: 27	1	005	1001	FIRE ALARM			Area 1 reported a fire alarm, zone Smoke Relay on January-08-17 at 3:27:00 PM
    01/08/2017 15: 28	1	006	1008	CARBON MONOXIDE ALARM, ANY AREA	Area 1 reported a carbon monoxide alarm, any area, zone CO Relay on January-08-17 at 3:28:00 PM
    01/08/2017 15: 37	1	027	1011	GAS ALARM, ANY AREA		Area 1 reported a gas alarm, any area, zone Kitchen Gas on January-08-17 at 3:37:00 PM
    Perhaps something to do with the area filter? The Elk M1 reports "ANY AREA" for gas and co, but not fire. The plugin does not let me choose "any area".

    Any ideas on how to troubleshoot? Thank you in advance for your time.
Working...
X