Announcement

Collapse
No announcement yet.

Analog zone only showing "1 volt"

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Analog zone only showing "1 volt"

    I have two analog zones configured on my Elk M1, zones 193 and 194. HomeSeer sees them as "analog zones", however it only ever reports the voltage as "1 volt" when the Elk M1 sees it at over 13.

    What Operating System Are You Using? Windows 7
    Are you running HomeSeer as a service? No
    How is HomeSeer connected to the Elk M1? M1XEP
    Do you run any anti-virus programs? No
    Are you able to duplicate the issue? Yes

    Debug log and screenshots sent to your e-mail. Thank you in advance for your assistance.

  • #2
    I just sent you an e-mail requesting a screenshot of the HomeSeer device "Advanced" tab associated with zone 193 and 194.

    Regards,
    Ultrajones
    Plug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR

    Comment

    Working...
    X