UltraM1G HSPI - Feature Requests

[karib]

Ability to "turn off" the humidity column for thermostats that don't have that sensor.

Is there any way to figure out if the thermostat has "tripped" and is calling for heat/cold?

Is there a way to trigger a "Test your connection" event other than on the elk? Something like "There was a power failure, trigger event to have alarm call the central station with a test call"?

[Ultrajones]

I checked with Elk Tech Support and there is no way to get access to the 64 counters using the ASCII Protocol. However, they do allow access to the 20 custom values that can be of type "number", "timer" or "time of day". I'll add access to those 20 custom values.

Regards,
Ultrajones

[kuntakintay]

Counter Support - Previously posted the request in a different thread...

[Ultrajones]

Post your feature requests here.

Outstanding feature requests:

• Add ethernet support using the Elk M1XEP [complete]
• Add thermostat support [complete]
• Added the ability to change the Elk M1XEP non-secure port [complete]
• Add watchdog timer [complete]
• Detect when the ELKRP connects to the Elk M1 panel and provide a HomeSeer trigger for this event [complete]
• Add support for reading and writing the "Custom Settings" stored in the Elk M1 [complete]
• Add support for Elk M1 Lighting [complete]
• Display different status icon for zones defined as Non Alarm [complete]
• Add option to set temperrature polling interval [Not needed, newer Elk Firmware sends temperature changes]
• Trigger event based on user disarming system [complete]
• Add an Elk M1 Timesync Action [complete]
• Trigger event based on System Trouble Status [complete, requires firmware > 4.5.2, 5.1.2]
• Add Zone and Output names to triggers, conditions and actions. [complete]
• Speak words and phases via scripting interface. [complete]
• Add support to use custom keypad codes (6 digits) or Weigand data cards to trigger HomeSeer events. [complete]
• Add GetZoneStatusEx, GetOutputStatusEx to scripting API. [complete]
• Add Elk Lighting dimming support. [complete]
• Add the ability to create for more than 99 inputs, outpus and ligthing HomeSeer devices. [complete]
• Add HomeSeer device that tracks last user action (arm|disarm). [complete]
• Add support for counters.[complete]

• Add ability to create an input and output device for each keypad.
• When adding HomeSeer devices for thermostats, make it so each of the thermostat items can be added individually.
• Add an option to allow the UltraM1G plug-in to reload data from the Elk M1 when the ElkRP software disconnects.
• Force a re-sync after the ElkRP disconnections.

Regards,
Ultrajones