I have my insteon plc connected to my homeseer pc and everything works without any problems.
I was attempting to use the keyfobs to turn on and off insteon controlled lights, but I can not figure out how to do it. If I make the keyfob input zone a homeseer device and make an event it does not allow you to choose what the buttons do.
Am I missing something simple here? Or do I do it indirectly where I need to set up rules in the elk where if I press a keyfob button then it turns on output xxx and when homeseer detects output xxx is on then turn on light.
Thanks,
CT
I was attempting to use the keyfobs to turn on and off insteon controlled lights, but I can not figure out how to do it. If I make the keyfob input zone a homeseer device and make an event it does not allow you to choose what the buttons do.
Am I missing something simple here? Or do I do it indirectly where I need to set up rules in the elk where if I press a keyfob button then it turns on output xxx and when homeseer detects output xxx is on then turn on light.
Thanks,
CT
Comment