Question on triggering from a Device

[bdhall]

Is "Device Value Change" and selecting becomes on (or off) the proper way to look at on/off operation of the devices created by your plug-in for Elk M1G Zones and outputs? This seems to work ok.

I started out trying to use "Device Status Change" but I did not get that to work. Is this supported?

Wanted to make sure I am doing this correctly.

Thanks!
Brian

[Ultrajones]

Is "Device Value Change" and selecting becomes on (or off) the proper way to look at on/off operation of the devices created by your plug-in for Elk M1G Zones and outputs? This seems to work ok.

I started out trying to use "Device Status Change" but I did not get that to work. Is this supported?

Wanted to make sure I am doing this correctly.

Thanks!
Brian

You need to test for a Device Value change for zones, outputs, etc. These HomeSeer devices are created using device value pairs.

I don't believe I change the device status for outputs, so testing for a device status change won't work and is not supported.

Regards,
Ultrajones