Announcement

Collapse
No announcement yet.

Error when trying to Arm M1 from HS Pro

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Error when trying to Arm M1 from HS Pro

    Hi, When I tried to arm (away or stay)/disarm my ELK M1 from HS Pro I get the following error. Appreciate any help.

    ---------------

    7/13/2011 2:07:24 PM UltraM1G Warning No response/improper response from Elk M1 to command 'a2100453000'
    7/13/2011 2:07:23 PM UltraM1G Warning Raw data was: 1EAS00000000111111110000000000E2
    7/13/2011 2:07:23 PM UltraM1G Warning Invalid checksum 212 for command AS as data 000000001111111100000000
    7/13/2011 2:07:23 PM UltraM1G Info Access keypad 01 was case by Chris on Wednesday, July 13, 2011 at 2:07:00 PM

    Plug-In Status
    Name: HSPI UltraM1G
    Status: OK
    Version: 1.1.4082.26173
    Plug-In House Codes
    Base: [
    Users: $
    Inputs: \
    Outputs: ]
    Counters: Unassigned
    Lighting: `
    Themostats: Unassigned
    M1G Panel Status
    Connection Status: Connected
    M1G Firmware: 05.02.6
    M1XEP Firmware: 01.03.1A
    Commands In Queue: 0
    Last Receive Event: 7/13/2011 2:22:30 PM
    M1G Logs
    Log Count: 38
    Supported Elk M1 Configuration
    Areas: 8 [3 defined]
    Keypads: 16 [1 defined]
    Users: 202 [1 defined]
    Zones: 208 [64 defined]
    Outputs: 208 [64 defined]
    Thermostats: 16 [0 defined]
    Custom Settings: 20 [16 defined]
    Counters: 64 [16 defined]
    Tasks: 32 [16 defined]
    Lighting: 256 [16 defined]

    #2
    Hello. This is caused by a attribute associated with the account definition. You'll need to sign into the elkrp program and change an attribute. Unfortunatly, I am away from my computer, so I won't be able to tell you what the attribute is, but it should be easy to figure out.

    Regards,
    Ultrajones
    Plug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR

    Comment


      #3
      Could you give me a little hint - The only attribute I can think of is the password and its set the same on both.

      Cheers

      Comment


        #4
        To resolve this issue, simply remove the "access" bit from the existing user or create a new user to control HomeSeer without the "access" bit set.
        Plug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR

        Comment

        Working...
        X