Announcement

Collapse
No announcement yet.

Output expander M1RB does not work after firmware upgrade

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Output expander M1RB does not work after firmware upgrade

    I recently upgraded my Elk Firmware to 5.3.10 and I cannot get the M1RB output to work anymore? The M1RB J1 is connected directly to M1G J16. I tried to turn on the output zone and the light does not come on one of the zone on the M1RB board?
    I also tried to use the script in the Elk M1G and it will not work either?

    I did a voltage test on the M1G J16 and it shows voltage going out. Did you have any trouble with the M1RB when you upgraded the firmware?

    I am current using the following versions below.
    Main Program ELRP2 2.0.34
    UltraM1G 3.0.6020.17037
    Status connection - Ok
    M1G firmware 5.3.10

    Thanks

    James
Working...
X