UltraM1G3 connection Issue

[Miamijerry]

Just installed the UltraM1G3 plugin
Set the IP address in options to the static IP address of the Elk MiG
Port matches port in M1XEP, which is set to "Non-secure", G35 to G40 are set to "Yes".
ElkRP2 software connects fine.
Re-started Homeseer

Shows disconnected in status of UltraM1G3 plug in,
Suggestions ??

Note, I had the UltraECM plugin working, then one day, it would never connect, and I never was able to resolve that issue.

Computer has two networks ??

Firewall issue ??

Update - Edited UltraM1G3.exe to run as administrator, and gave access thru firewall, still no connection.

I have this after enabling debug log;
No connection could be made because the target machine actively refused it

RESOLVED

Apparently on the M1XEP setup screen in Elkrp2, I had not sent the change to "Non-secure" port to the M1XEP by pressing the "Send" button.

[Krumpy]

Yeah, the secure port requires a certificate (potentially a specific certificate) for its communication. Always use unsecure port.