I haven't seen this mentioned, but the HAI Omni (which HomeSeer supports) and the Way2Call both use the same "#" to operate their interfaces. On the Omni, I don't see any way to change that behavior. I don't have a Way2Call, but haven't seen anything mentioned about an alternative there either. Is there a way to use Way2Call with an Omni and HomeSeer, and get to both the Way2Call and the Omni phone interface without conflicts?
Announcement
Collapse
No announcement yet.
Way2Call with HAI
Collapse
X
-
anogeeTags: None
-
Personally I just put one on one phone line and the other on another... ;-)
Look in the SETTINGS.INI file for gCommandKey under the [hsphone] section. If it is not there, add it. You can change this to * if you want so it will not conflict with the HAI's # key which, as you pointed out, is not changeable.
Regards,
Rick Tinker
HomeSeer Technologies
Regards,
Rick Tinker (a.k.a. "Tink")
Comment