HS will only recognize incoming calls, and announce the caller, one time after I configure the Way2Call in the "Line Specific Settings" section. If I select the W2Call device to open up all the configuration sections, and then click "Save" all the settings are saved. I get the following entries in the log:
11/20/2008 4:00:05 PM Info Initializing Hi-Phone device...
11/20/2008 4:00:05 PM HSPhone Resetting line: Line 1
11/20/2008 4:00:05 PM HSPhone Calling hangup for line: Line 1
11/20/2008 4:00:05 PM HSPhone Enter OpenLine, line: Line 1
11/20/2008 4:00:05 PM HSPhone Finished Resetting line: Line 1
HS will recognize and announce the first incoming call after that:
11/20/2008 4:01:36 PM HSPhone Ring
11/20/2008 4:01:40 PM HSPhone CID Name: CRANFORD D CID Number: 501xxxxxxx
11/20/2008 4:01:40 PM Info Caller ID Name: CRANFORD D Number: 501xxxxxxx
11/20/2008 4:01:40 PM HSPhone Searching for a match on CID. CID Num is: 501xxxxxxx
11/20/2008 4:01:40 PM HSPhone Caller is not set to pop up CID information
11/20/2008 4:01:40 PM Info Speak ():Excuse me, you have a call from line 2
11/20/2008 4:01:40 PM HSPhone Found match in address book
11/20/2008 4:01:40 PM HSPhone Incoming call. From: David Cranford 501xxxxxxx
11/20/2008 4:01:42 PM HSPhone Ring
11/20/2008 4:01:48 PM HSPhone Ring
But, after that, HS will not recognize an incoming call until I save the Way2Call settings again.
(Note, I edited the phone number. The real phone number is displayed in the HS log).
11/20/2008 4:00:05 PM Info Initializing Hi-Phone device...
11/20/2008 4:00:05 PM HSPhone Resetting line: Line 1
11/20/2008 4:00:05 PM HSPhone Calling hangup for line: Line 1
11/20/2008 4:00:05 PM HSPhone Enter OpenLine, line: Line 1
11/20/2008 4:00:05 PM HSPhone Finished Resetting line: Line 1
HS will recognize and announce the first incoming call after that:
11/20/2008 4:01:36 PM HSPhone Ring
11/20/2008 4:01:40 PM HSPhone CID Name: CRANFORD D CID Number: 501xxxxxxx
11/20/2008 4:01:40 PM Info Caller ID Name: CRANFORD D Number: 501xxxxxxx
11/20/2008 4:01:40 PM HSPhone Searching for a match on CID. CID Num is: 501xxxxxxx
11/20/2008 4:01:40 PM HSPhone Caller is not set to pop up CID information
11/20/2008 4:01:40 PM Info Speak ():Excuse me, you have a call from line 2
11/20/2008 4:01:40 PM HSPhone Found match in address book
11/20/2008 4:01:40 PM HSPhone Incoming call. From: David Cranford 501xxxxxxx
11/20/2008 4:01:42 PM HSPhone Ring
11/20/2008 4:01:48 PM HSPhone Ring
But, after that, HS will not recognize an incoming call until I save the Way2Call settings again.
(Note, I edited the phone number. The real phone number is displayed in the HS log).
Comment