Announcement

Collapse
No announcement yet.

Aeotec Multisensor 6 Temp Calibration

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Aeotec Multisensor 6 Temp Calibration

    Has anyone messed around with calibrating the Multisensor 6? There's something about using an Excel Spreadsheet to get the Hex parameter, and entering that into one of the parameters.

  • #2
    Originally posted by tome10 View Post
    Has anyone messed around with calibrating the Multisensor 6? There's something about using an Excel Spreadsheet to get the Hex parameter, and entering that into one of the parameters.
    I answered your other post and attached the engineering spec sheet.
    Randy Prade
    Aurora, CO
    Prades.net

    PHLocation - Pushover - EasyTrigger - UltraECM3 - Ultra1Wire3 - Arduino

    Comment


    • #3
      I see it, thanks.

      Comment


      • #4
        I use my own script which writes a corrected value to a virtual device. However, I have perhaps 10 of these sensors and have noticed that these sensors are very inaccurate and not linear. When the sensor is cold or hot, their temperature readings can vary by 10 to 20 degrees from actual. They do better around 'comfort zone' temps. If direct sun hits them, they can read 110 on an 80 degree day.

        I'd like to find an accurate, linear and cheap z-wave temperature sensor.

        - Robert

        Comment


        • #5

          Comment

          Working...
          X