Hi All,
I'm getting these errors consistently despite the fact that I can control the thermostat via serial. I've reviewed this thread a few times:
http://board.homeseer.com/showthread.php?t=105482
and I'm fairly confident in my wiring, however the cables are not soldered/crimped properly. Additionally the serial cable is just a ten foot serial cable cut in half. Could these errors be created from 'noise' in the cable caused by the alligator clamps and twisted leads from the serial cable or is there something else I should be looking for?
Additionally, HS reports that the thermostat is reporting -48 degrees while it shows 64 degrees on the unit itself.
Thanks,
Jason
I'm getting these errors consistently despite the fact that I can control the thermostat via serial. I've reviewed this thread a few times:
http://board.homeseer.com/showthread.php?t=105482
and I'm fairly confident in my wiring, however the cables are not soldered/crimped properly. Additionally the serial cable is just a ten foot serial cable cut in half. Could these errors be created from 'noise' in the cable caused by the alligator clamps and twisted leads from the serial cable or is there something else I should be looking for?
Additionally, HS reports that the thermostat is reporting -48 degrees while it shows 64 degrees on the unit itself.
Thanks,
Jason
Comment