-
Since you have an RC-2000 Occupancy is supported natively by the thermostat. If it is not working for you, check the settings on your thermostat and make sure the program mode is set to occupancy.Leave a comment:
-
Thanks. I actually just found it an hour ago and installed it already. It looks great! Thanks. I was trying the Day, Night, Away, and Vacation modes. I couldn't seem to get them to work. I have an RC-2000.
The modes are changing, but the set points are not.Last edited by email68; June 11, 2015, 05:09 PM.Leave a comment:
-
If you use the free alternative plugin that I wrote, you would specify the HS device that has the temperature using the configuration screen.
Read about it at http://board.homeseer.com/showthread.php?t=174446Leave a comment:
-
How to display the outside temp on HS3 plugin?
On the HS2 plugin for HAI thermostat you could enter an outside temp variable that would show up on the thermostat. How can I do that on the new plugin for HS3?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Leave a comment: