Heat/Cool adjustments not working

[bbos]

Spud, I've been using your plugin to create effect, thx. Today I ran into an issue. I placed my stats in Heat/Cool mode and found that adjusting the temp via the high and low settings is not working. I tried both from the device page and from an event. Updating the temp on the stat directly IS still reflected on the device page, so communications is happening.

If I switch back to Cool mode, the function works normally again.

I'm on v3.0.0.34 and i'm not seeing any errors in the logs.

Any ideas?

(thx in advance)!

Bill

Current Date/Time: 10/28/2019 1:42:37 AM
HomeSeer Version: HS3 Standard Edition 3.0.0.534
Linux version: Linux hometrollerSEL 3.16.0-031600-generic #201408031935 SMP Sun Aug 3 23:56:17 UTC 2014 i686 i686 i686 GNU/Linux System Uptime: 1 Day 17 Hours 32 Minutes 20 Seconds
IP Address: 127.0.0.1
Number of Devices: 298
Number of Events: 92
Available Threads: 199
HSTouch Enabled: True
Event Threads: 0
Event Trigger Eval Queue: 0
Event Trigger Priority Eval Queue: 0
Device Exec Queue: 0
HSTouch Event Queue: 0
Email Send Queue: 0

Enabled Plug-Ins
2.0.11.0: BLEditor
3.0.28.0: BLLock
1.0.1.0: BLTEDPro
1.3.7.3: Device History
3.0.0.34: Nest
19.6.3.1: TPLinkSmartHome
3.0.1.252: Z-Wave

[spud]

Set the log level to Debug from the config page, and post what you get when you try to change the setpoint.