-
Via a script, you can send the following:
call RCS.cmdsendcustom(1,"OT=" & hs.DeviceValue("W11"))Leave a comment:
-
How to send command to thermostat
I am new in using the plug-in 2.4.0.2 with RCS TS40.
Is there way to send a generic command to the thermostat? I am trying to set outside temperature value on the stat without outside sensor (command "TO=xxx")?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Leave a comment: