I just can't seem to get events that use this PI to fire. What am I missing? I literally copied the log entry so I know the syntax is correct.
The event is to fire off after I turn off my alarm system. I tried to do this with EasyTrigger, but found that depending on when/how I turned off the alarm, I was getting different states that wouldn't fire. so I added the BLLogMonitor entries as well as a backup.
Here's the alarm going off via the HS Log. Below is a snippet of the event. any thoughts GREAT appreciated as I use this to turn off the red LEDs blinking (to indicate alarm ON) on ALL of my HD200 dimmers.
The event is to fire off after I turn off my alarm system. I tried to do this with EasyTrigger, but found that depending on when/how I turned off the alarm, I was getting different states that wouldn't fire. so I added the BLLogMonitor entries as well as a backup.
Here's the alarm going off via the HS Log. Below is a snippet of the event. any thoughts GREAT appreciated as I use this to turn off the red LEDs blinking (to indicate alarm ON) on ALL of my HD200 dimmers.
Nov-09 11:46:39 AM | Vista Alarm | ****DISARMED**** Ready to Arm |
Nov-09 11:46:31 AM | Vista Alarm | FAULT 10 INSIDE GARAGE DOOR |
Nov-09 11:46:30 AM | Vista Alarm | ****DISARMED****Hit * for faults |
Nov-09 11:46:30 AM | Vista Alarm | Sending Display Faults command to alarm |
Nov-09 11:46:26 AM | Z-Wave | Device: Laundry Room Light Overhead Set to 255 |
Nov-09 11:46:26 AM | Device Control | Device: Laundry Room Light Overhead to On (255) |
Nov-09 11:46:26 AM | Event | Event Trigger "Laundry Room Laundry Room Motion - Light ON" |
Nov-09 11:46:26 AM | Z-Wave | Device: Laundry Room Motion Sensor Motion Sensor Set to On/Open/Motion |
Nov-09 11:46:25 AM | Vista Alarm | DISARM SYSTEM or alarm occurs |
Comment