Announcement

Collapse
No announcement yet.

Aeon Labs Multisensor 6

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • taiello6683
    replied
    Multisensor 6 with Homeseer zwave plugin

    I've been messing with two of these sensors for several days and cannot seem to get them to work reliably. In particular I need some insight into the tampering function. Every time I touch the sensor it sets off the "cover removed/Tampering" event. That takes several minutes to recover but then it goes into the "Unknown" state -- value=254 and seems to sit there indefinitely If I reset the sensor it might work for a while but if I bump it (or just try to install it on it's mount) it goes right back to the tampering issue. Has anyone else had this issue? I've tried firmware 1.07 and 1.08, same results. Thanks in advance.

    Leave a comment:


  • Blade
    replied
    No problem - glad you got them working

    Leave a comment:


  • Gogs
    replied
    Originally posted by Blade View Post
    Capture a debug log of one triggering and let me know the device reference so I can trace it though
    Hi Bob, sorry you are going to love this. Read in another post that parameter 4 should be set to 5 prior to my original post above. In HS that will show as motion disabled, but in fact it is.

    When I triggered it to create the debug log it worked perfectly, I'll keep an eye on it for the next few days.

    Sorry to have taken up your time.

    Leave a comment:


  • Blade
    replied
    Capture a debug log of one triggering and let me know the device reference so I can trace it though

    Leave a comment:


  • Gogs
    replied
    Originally posted by Blade View Post
    Did you set them up as a value triggered device? You may need to go the device status graphic pairs to get the values
    Yes they are set as value triggered.

    Leave a comment:


  • Blade
    replied
    Did you set them up as a value triggered device? You may need to go the device status graphic pairs to get the values

    Leave a comment:


  • Gogs
    started a topic Aeon Labs Multisensor 6

    Aeon Labs Multisensor 6

    I have a few Aeon Labs Multisensor 6 units, and cannot get them to work with BLRader. I can set them up as a motion sensor and they do trigger, however the associated occupancy sensor does not trigger????
Working...
X