Announcement

Collapse
No announcement yet.

HSM200

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • HSM200

    How do I set up the new HSM200 to work with BLRadar?

  • #2
    When adding the sensor, make sure to check the value triggered area and put in the ON and OFF value for the sensor
    Cheers,
    Bob
    Web site | Help Desk | Feature Requests | Message Board

    Comment


    • #3
      I tried that. I tried with 100 and 7 as motion on parameters. If motion is triggered, the device status shows 100=motion. But on the status graphics tab the value 7 is listed for motion so I tried both. I don't know what the 7 represents. Thanks.

      Comment

      Working...
      X