I have a selection of radiator valves installed on my ZWave network, controlled by HS3 and have recently installed BLStat.
As far as HS3 is concerned, the 2 types of TRV are working fine. You can adjust the setpoints manually and the new values are reported in HS3, and you can also alter the setpoints from HS3 and they are reflected on the TRV.
However in BLStat's thermostat screen, I can see the value of a Danfoss setpoint but cannot alter it. Nor will the setpoint be adjusted according to a schedule. These features do work for the Eurotronic Spirit TRV however.
Any suggestions?
Thanks in advance
As far as HS3 is concerned, the 2 types of TRV are working fine. You can adjust the setpoints manually and the new values are reported in HS3, and you can also alter the setpoints from HS3 and they are reflected on the TRV.
However in BLStat's thermostat screen, I can see the value of a Danfoss setpoint but cannot alter it. Nor will the setpoint be adjusted according to a schedule. These features do work for the Eurotronic Spirit TRV however.
Any suggestions?
Thanks in advance