Just replaced an APC UPS with a Cyberpower CP1500PFCLCD. Installed their PowerPanel software which worked fine.
Then I remembered the BLUPS plug-in that I had always wanted to try, and installed that. Received the following error:
Legacy-Plugin BLUPS Init Error No UPS battery could be found!
Reading through the forum, I saw that with APC units, the Powerchute software will stop the plug-in. So I assumed the same for CyberPower and uninstalled their software.
Still got the same error when starting the plug-in.
Deleted the battery from the Windows 10 device manager to make sure the driver would reload without any PowerPanel driver, uninstalled the plug-in and reinstalled.
Same error. Also upgraded to HS4 a couple of weeks ago.
Any thoughts on how to fix this?
Then I remembered the BLUPS plug-in that I had always wanted to try, and installed that. Received the following error:
HomeSeer Error Initializing plug-in(1): BLUPS Instance::No UPS battery exists on this system so this plugin will not run! Time to load: 81 milliseconds
Legacy-Plugin BLUPS Init Error No UPS battery could be found!
Reading through the forum, I saw that with APC units, the Powerchute software will stop the plug-in. So I assumed the same for CyberPower and uninstalled their software.
Still got the same error when starting the plug-in.
Deleted the battery from the Windows 10 device manager to make sure the driver would reload without any PowerPanel driver, uninstalled the plug-in and reinstalled.
Same error. Also upgraded to HS4 a couple of weeks ago.
Any thoughts on how to fix this?
Comment