HS4 Linux Build 37 - Changing Event trigger when using Groups

[andyf]

Just to let you know, I'm running HS3 w/ exact same event (two MyQ garage doors in the Group) ... it triggers fine for me everytime.

If you create the event with that trigger it works fine. If you create the event with "has changed and becomes <a value>" and then change your mind and edit it to "has changed" only is when it fails to trigger.

[Ltek]

If
"Any device in Group Garage has just changed"
Then

Just to let you know, I'm running HS3 w/ exact same event (two MyQ garage doors in the Group) ... it triggers fine for me everytime.

[andyf]

I have a few events that use Groups as a trigger as in:

If
"Any device in Group Garage has changed and becomes 0"
Then

This triggers OK, but if I go and edit the trigger to:

If
"Any device in Group Garage has just changed"
Then

The event will not trigger. Instead of just being able to edit the trigger I have to delete the event and create a new event with the new trigger and it works just fine then.
This may have failed in HS3 also but I didn't need to alter the trigger in HS3. Some behavior in HS4 forced me to change the trigger.