Sorry for all the questions but just starting out with EasyTrigger. I am trying to setup a Group of Virtual Presence Sensors. I have them setup in a Room called "Presence Sensors" and I have set them up as a Type "Presence". When setting up the Group I have setup a Rule that the Room Equals Presence Sensor but after I save it and hover over the little ? it says empty. I don't get it...what am I doing wrong? I also tried it with the above rule and also Type equals Presence and still nothing.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment