Announcement

Collapse
No announcement yet.

Devices not loaded

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Devices not loaded

    Hi

    Newbie install problem.

    I looked in the forum and found the same problem but no real answers to this.

    I downloaded off the updater the latest version and installed fine. If I click on setup it goes to localhost but I have a specific IP set so I manualy went to the config page.

    The floor plan loads fine but no devices are loaded and that is as far as I can get.

    Is there an FAQ or install manual so I don't ask dumb questions

    Any help would be appreciated.

  • #2
    I am in the process of updating the hspi ultrastatus plugin (including the floor plan view). I'll be providing a step by step setup next update.

    Did you try the troubleshooting steps listed here:

    Troubleshooting Hints:

    Make sure each of the following URL's load completly without error:

    http://localhost/status?pg=xml_status

    http://localhost/status?pg=xml_devices

    http://localhost/status?pg=xml_locations

    http://localhost/status?pg=xml_positions

    It is ok if they don't contain any elements, but they must load without errors.
    Plug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR

    Comment

    Working...
    X