Hello, none of my UPB light switches seem to be able to be controlled via the plug-in. In the device configuration page in Homeseer, only the Blink control is shown. This is different from the Zwave devices that I have where On and Off can be controlled as expected.
-
-
did you setup everything in Upstart, then export the Upstart config, finally import it into the UPB plugin?
--DanTasker, to a person who does Homeautomation...is like walking up to a Crack Treatment facility with a truck full of 3lb bags of crack. Then for each person that walks in and out smack them in the face with an open bag. -
My upb network is imported, yes. All the devices show up in the homeseer status page and have on/off/blink listed there, but the on/off options do not show up in the InControl section for the device configuration - only blink shows up.Originally posted by drozwood90 View PostComment
-
I enclosed the screenshots.Attached FilesComment
-
-
Any ideas? I have submitted config files to Laman support anyway.Comment
Comment