Announcement

Collapse
No announcement yet.

Events based on Wind?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Events based on Wind?

    I created devices for "Wind speed average" and "Wind direction average" I need to create an event that performs action based in these, but only conditions for the created devices are on, off, or value ranges. Is there a way to accomplish this?
    (Forgive me if this is a stupid question, as I'm very new to HomeSeer)

  • #2
    You should use the HomeSeer device value for triggers and conditions. For wind direction devices, the following values are used:

    "N", "North": 0
    "NNE", "NorthNorthEast": 23
    "ENE", "EastNorthEast": 68
    "E", "East": 90
    "ESE", "EastSouthEast": 113
    "SE", "SouthEast": 135
    "SSE", "SouthSouthEast": 158
    "S", "South": 180
    "SSW", "SouthSouthwest": 203
    "SW", "Southwest": 225
    "WSW", "WestSouthwest": 248
    W", "West": 270
    "WNW", "WestNorthwest": 293
    "NW", "Northwest": 315
    "NNW", "NorthNorthwest": 338

    Note: Wind decimal values were rounded up.

    For wind speed devices, just use the value range for a trigger or condition.

    Does this help?

    Regards,
    Ultrajones
    Plug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR

    Comment


    • #3
      Thanks! That's what I was looking for.

      Comment

      Working...
      X