Running latest version of BLRF on HS3 latest version... I run a serial W800 to detect wireless X10 commands from MS13a motions.
Hello,
I am trying to run events based on x10 commands being received from a motion sensor (MS13a). The log shows that BLRF hears the X10 command but does not do anything with it.
I have created a virtual device to change status based on received commands but that does not change status.
I have added a new X10 devices with the same code as the motion but also does not changes status
The log does show the correct X10 commands being received...
Hoping you can help.
Hello,
I am trying to run events based on x10 commands being received from a motion sensor (MS13a). The log shows that BLRF hears the X10 command but does not do anything with it.
I have created a virtual device to change status based on received commands but that does not change status.
I have added a new X10 devices with the same code as the motion but also does not changes status
The log does show the correct X10 commands being received...
Hoping you can help.