Anyone else using multiple W800's in BLRF in HS3? I seem to have an issue where both receivers work for a while and then one or the other stops receiving commands. If I disable/enable the plugin or restart HS it might start working again or only one or the other will work. I have tried setting it from mscommlib to serial and back again, but seem to get the same results. I have tried to turn on debug logging and although I can either capture both working or just one of them I haven't been able to get an instance where I find it stop working while the logging is running. The receivers are on opposite ends of the house so when it isn't working I normally start missing commands from which ever on isn't currently receiving. In the most recent version receiver 2 was working as all the debug shows entries from it:
ReceiverW800MessageData:
------------------------
receiverNumber: 2
The previous time I tested it was number 1 that was working. I have also swapped the order of the receivers in the options page, but that doesn't seem to help. I will try to capture logging when it actually stops, but so far I don't see any errors that would cause one or the other to stop.
Running 2.0.74 BLRF
and .152 of HS3
Thanks,
Jeff
ReceiverW800MessageData:
------------------------
receiverNumber: 2
The previous time I tested it was number 1 that was working. I have also swapped the order of the receivers in the options page, but that doesn't seem to help. I will try to capture logging when it actually stops, but so far I don't see any errors that would cause one or the other to stop.
Running 2.0.74 BLRF
and .152 of HS3
Thanks,
Jeff
Comment