Trying to add Meade Sensors

[gerlin]

I have 4 Oregon THGR810 sensors all working well. It seems they are no longer readily available so I picked up 2 Meade TS34C-M, which show as supported on "http://www.rfxcom.com/oregon/en".

However, they are not showing up on my RFXCOM Input Devices as new available sensors.

I was not sure what type to use as far as the RFXrec setup, so I enabled them all, still no luck. Tried changing the channels on the sensors, no luck.

Are these supported by the HS3 RFXCOM plugin? I see on the release notes for 30.0.0.36 back in 2017 Meade sensors listed.

Is there something I need to do differently than my old THGR810 sensors to get the system to see them? I have them right next to the RFXrec433 unit.

Any help is appreciated.



Receiver: RFXrec433
HS3 3.0.0.548
RFXCOM 30.0.0.41
OS: Windows 10 Pro

[b_weijenberg]

Check charter 2.2.2 in the RFXtrx User Guide which firmware type support this sensor and enable only hideki for this sensor.
If you enable all it will not operate.

[gerlin]

Thanks, (and thanks for the quick response), I am all set now. I will make sure I reference that doc for future reference.