Team,
I have a number of X10 motion sensors (MS13) in HS4 that are working fine. These were migrated from HS3.
The way to configure these was:
- set the MS13 to transmit on house/unit code "B12"
- in HS you configure the house/unit code "B12"
However, in HS4 the is no such concept?
Is there an official way to configure this device or is the only way to configure the HC/DC using Jon00's Legacy pages?
DJ
I have a number of X10 motion sensors (MS13) in HS4 that are working fine. These were migrated from HS3.
The way to configure these was:
- set the MS13 to transmit on house/unit code "B12"
- in HS you configure the house/unit code "B12"
However, in HS4 the is no such concept?
Is there an official way to configure this device or is the only way to configure the HC/DC using Jon00's Legacy pages?
DJ