Alright, I have an Ocelot and SECU-16. Running Homeseer (version 2.3.0.19) installed the Homeseer Ocelot Plug-in (version 2.1.0.0).
My questions:
1. In the configure interface box: Units discovered: Unit 0 Ocelot/CPU-XA/Leopard. Should I also see the SECU-16 or is the fact it is hooked to the Ocelot all that matters to Homeseer?
2. From the configure interface box I select "Create Devices"...I now have 128 Ocelot Variables in my device lists...how do I map any of those to the SECU-16?
3. First thing I would like to do is just turn on/off relay #1 (I/O Point 8) based on a Homesser event...I guess if I get my first 2 questions answered I can answer this one.
And yes I can toggle that relay with the C-Max software so I know the hardware setup works.
Thanks in advance...
My questions:
1. In the configure interface box: Units discovered: Unit 0 Ocelot/CPU-XA/Leopard. Should I also see the SECU-16 or is the fact it is hooked to the Ocelot all that matters to Homeseer?
2. From the configure interface box I select "Create Devices"...I now have 128 Ocelot Variables in my device lists...how do I map any of those to the SECU-16?
3. First thing I would like to do is just turn on/off relay #1 (I/O Point 8) based on a Homesser event...I guess if I get my first 2 questions answered I can answer this one.
And yes I can toggle that relay with the C-Max software so I know the hardware setup works.
Thanks in advance...
Comment