Timerlinc - won't work with PLM

[DuaneT]

I just updated from PLC to PLM and I cannot get my timerlincs to work. Are they supported using the PLM? The PLM can see the timerlinc but it cannot read or write to the link tables so they don't work.

[mnsandler]

I just updated from PLC to PLM and I cannot get my timerlincs to work. Are they supported using the PLM? The PLM can see the timerlinc but it cannot read or write to the link tables so they don't work.

what is the devicetype (a four digit number) and firmware ver of the timerlinc? look in the insteon.ini in the appropriate [device x] section

[DuaneT]

what is the devicetype (a four digit number) and firmware ver of the timerlinc? look in the insteon.ini in the appropriate [device x] section

Mark,

Thanks for the reply. Here is what you asked for and some additional info I forgot to put into my original message:

My HomeSeer version is: 2.4.0.11

PLM Plugin is: 1.4.2.0

When I try and add the device I get the message:

This plug-in was able to contact your device but the link table could not be read. This device can be controlled through HomeSeer and can be polled but instant change notification is not available.

When you go to edit this device this is what appears in the Device Link Table:

Warning: The links for this device have not been downloaded. Please use the 'Setup/Program Device' option to properly setup the device.

And here is the insteon.ini info:

DeviceID=10.DB.31
DeviceName=TimerLinc
DeviceLocation=House
PollingInterval=0
DeviceType=0207
FirmwareVer=38

Duane

[mnsandler]

yes, this devicetype is not currently supported. I'll have to get the specs from SH so i can add it to the next release.

[DuaneT]

yes, this devicetype is not currently supported. I'll have to get the specs from SH so i can add it to the next release.

Thanks, I will keep an eye out for the next release.

Duane