Announcement

Collapse
No announcement yet.

Motion Detector Issue

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Motion Detector Issue

    Numerous 2420's that normally trigger events from motion and or dusk/dawn detection.

    2413 and 4, 2433 wireless access points in home.

    About 30 hours ago, motion and dusk/dawn changes failed to trigger any events and the status list shows no changes. Activated detailed debugging logging and there appear to be entries relating to these devices.

    Have rebooted three times and no change.

    I'm confident that the 2420s are doing what they are supposed to do and that HomeSeer is seeing them. The events are not disabled.

    No changes in status list and no events run from these devices.

    Doesn't make sense to me. Replaced the 2413 recently, and it seems to be working fine. Any ideas? Thank you

    #2
    Update

    For some reason, the motion detector commands began to be seen by HomeSeer. I did a PLM hardware reset and reread all of the links although there had been no changes recently and it appeared that all of the motion detectors had their links intact.

    During this 2420 (multiple devices) the remaining handful of X10 motion detectors were doing everything they were supposed to do.

    Most of my 2420s are not linked to anything other than the PLM. Those that have direct links to devices (switches in my case) continued to control those devices properly when HomeSeer wasn't dealing with them.

    Will continue to watch and see.

    Comment


      #3
      What ver of the plugin are running? Try 1.5.5.10 found at the end of the 1.5.5.0 thread. There was a linking prob with the ms that I fixed. Should be three links on the ms device link edit page
      Mark

      HS3 Pro 4.2.19.5
      Hardware: Insteon Serial PLM | AD2USB for Vista Alarm | HAI Omnistat2 | 1-Wire HA7E | RFXrec433 | Dahua Cameras | LiftMaster Internet Gateway | Tuya Smart Plugs
      Plugins: Insteon (mine) | Vista Alarm (mine) | Omnistat 3 | Ultra1Wire3 | RFXCOM | HS MyQ | BLRadar | BLDenon | Tuya | Jon00 Charting | Jon00 Links
      Platform: Windows Server 2022 Standard, i5-12600K/3.7GHz/10 core, 16GB RAM, 500GB SSD

      Comment


        #4
        1.5.5.16. You sent that to me in response to another issue regarding the PLM replacement

        Comment


          #5
          so do you have three links for each MS back to the PLM?
          Mark

          HS3 Pro 4.2.19.5
          Hardware: Insteon Serial PLM | AD2USB for Vista Alarm | HAI Omnistat2 | 1-Wire HA7E | RFXrec433 | Dahua Cameras | LiftMaster Internet Gateway | Tuya Smart Plugs
          Plugins: Insteon (mine) | Vista Alarm (mine) | Omnistat 3 | Ultra1Wire3 | RFXCOM | HS MyQ | BLRadar | BLDenon | Tuya | Jon00 Charting | Jon00 Links
          Platform: Windows Server 2022 Standard, i5-12600K/3.7GHz/10 core, 16GB RAM, 500GB SSD

          Comment


            #6
            Links

            Yes I do. One of the first things I checked. I was out of town when the problem occurred, looks like it lasted for about 48 hours. Rebooted everything last night and or reasons unknown to me, everything started working fine last this morning. Seems to still be working fine.

            Comment

            Working...
            X