I installed EZFlora the end of last season, the warm weather is coming around and i am re-visiting the install and configuring zones, and water times..
I am unable to find any documentation regarding setup , and explaining of operation.
My questions are as follows
First off I Just want to confirm
Under Manual Timers For each zone
If i set the time in each zone if i turn on a zone using the valve control.. The manual timer should kick in and TURN off that zone, after the specified time... Correct??
And Under The Program Timers...
I am a little unsure how they work.. I need to confirm, that if i set two zones, to run for xx minutes, it will only turn on 1 zone at a time.. for xx minutes..
I understand this is a standard in lawn sprinkler controllers, that only one zone will turn on at a time, but since there is no documentation on this i just want to confirm and not asume. also, just want to find out the best practice to Time trigger an event.. Im again assuming i would just set a Program timer set up for my two zones, and then use a timed trigger event to activte that timed program..
Again I am assuming, i just want to make sure that it the way i should be setting times..
I am unable to find any documentation regarding setup , and explaining of operation.
My questions are as follows
First off I Just want to confirm
Under Manual Timers For each zone
If i set the time in each zone if i turn on a zone using the valve control.. The manual timer should kick in and TURN off that zone, after the specified time... Correct??
And Under The Program Timers...
I am a little unsure how they work.. I need to confirm, that if i set two zones, to run for xx minutes, it will only turn on 1 zone at a time.. for xx minutes..
I understand this is a standard in lawn sprinkler controllers, that only one zone will turn on at a time, but since there is no documentation on this i just want to confirm and not asume. also, just want to find out the best practice to Time trigger an event.. Im again assuming i would just set a Program timer set up for my two zones, and then use a timed trigger event to activte that timed program..
Again I am assuming, i just want to make sure that it the way i should be setting times..
Comment